FloPlast Cast Iron Effect Round Downpipe Bend

FloPlast

£32.98

92.5 Bends are used in a downpipe system to change the plane of the bend from vertical to horizontal or vice versa.They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup.The angle of the bend is 92.5 degrees rather than 90 degrees to encourage a slight fall, enabling rainwater to run away rather than sit in the pipe.For a quick introduction to this decorative fitting, please take a look at our PBSL Group video clip;

Buy Now →